Red Hat Linux 8.0: The Official Red Hat Linux Customization Guide | ||
---|---|---|
Prev | Chapter 29. Upgrading the Kernel | Next |
Now that you have the necessary kernel RPM packages, you can upgrade your existing kernel. At a shell prompt as root, change to the directory that contains the kernel RPM packages and follow these steps.
Important | |
---|---|
It is strongly recommended that you keep the old kernel in case you have problems with the new kernel. |
Use the -i argument with the rpm command if you want to keep the old kernel. If you use the -U option to upgrade the kernel package, it will overwrite the currently installed kernel (the kernel version and x86 version might vary):
rpm -ivh kernel-2.4.18-7.95.i386.rpm |
If the system is a multi-processor system, install the kernel-smp packages as well (the kernel version and x86 version might vary):
rpm -ivh kernel-smp-2.4.18-7.95.i386.rpm |
If the system is i686-based and contains more than 4 gigabytes of RAM, install the kernel-bigmem package built for the i686 architecture as well (the kernel version might vary):
rpm -ivh kernel-bigmem-2.4.18-7.95.i686.rpm |
If you plan to upgrade the kernel-source, kernel-docs, or kernel-utils packages, you probably do not need to keep the older versions. Use the following commands to upgrade these packages (the versions might vary):
rpm -Uvh kernel-source-2.4.18-7.95.i386.rpm rpm -Uvh kernel-docs-2.4.18-7.95.i386.rpm rpm -Uvh kernel-utils-2.4.18-7.95.i386.rpm |
If you are using PCMCIA (for example, a laptop), you also need to install the kernel-pcmcia-cs and keep the old version. If you use the -i switch, it will probably return a conflict because the older kernel needs this package to boot with PCMCIA support. To work around this, use the --force switch as follows (the version might vary):
rpm -ivh --force kernel-pcmcia-cs-3.1.24-2.i386.rpm |
If you are using the ext3 file system or a SCSI controller, you need an initial RAM disk. The purpose of the initial RAM disk is to allow a modular kernel to have access to modules that it might need to boot from before the kernel has access to the device where the modules normally reside.
The initial RAM disk is created by using the mkinitrd command. However, the Red Hat kernel RPM package performs this step for you. To verify that it was created, use the command ls -l /boot. You should see the file initrd-2.4.18-7.95.img (the version should match the version of the kernel you just installed).
Now that you have installed the new kernel, you need to configure the boot loader to boot the new kernel. Refer to the Section called Configuring the Boot Loader for details.