Pseudo Wire Emulation Edge to Edge WG (pwe3)

Wednesday, March 9 at 1530-1730
===============================

CHAIRS: Danny McPherson <danny@tcb.net>
        Stewart Bryant <stbryant@cisco.com>

AGENDA:

5 mins
Administrivia
Chairs (Stewart & Danny)
Agenda Bashing
Minutes
Blue Sheets

5 mins
WG Document Status
Danny McPherson <danny@tcb.net>
Stewart Bryant <stbryant@cisco.com>

20 mins
Pseudowire Setup and Maintenance using LDP and Ethernet over MPLS
Luca Martini
draft-ietf-pwe3-control-protocol-15.txt
draft-ietf-pwe3-ethernet-encap-09.txt
Restructure of drafts following AD review

10 mins
Frame Relay over Pseudo-Wires
Luca Martini
draft-ietf-pwe3-frame-relay-04.txt
Update on the rewrite

5 mins
PW Control Word
Stewart Bryant
<draft-bryant-mcpherson-pwe3-cw-02.txt>
Resolve any outstanding comments

15 mins
Requirements for inter domain Pseudo-Wires
Nabil Bitar
draft-martini-pwe3-MH-PW-requirements-00.txt

10 mins
Pseudo Wire (PW) OAM Message Mapping
draft-ietf-pwe3-oam-msg-map-02.txt
Mustapha Aissaoui

10 mins
PWE3 Applications & OAM Scenarios
Simon Delord
draft-delord-pwe3-oam-applications-00.txt
Introduction to Key Issues

10 mins
Pseudowire QOS Signaling
Himanshu Shah
draft-shah-pwe3-PW-qos-signaling-02.txt
Importance of QOS signaling, updates from last version
and QOS signaling in MH-PW

10 mins
Setup and Maintenance of Pseudowires using RSVP-TE
Rahul Aggarwal
draft-raggarwa-rsvpte-pw-01.txt
This draft describes a mechanism for setting up Multi-Hop PWs and
has been updated particularly to reflect the ongoing multi-hop
PW requirements work in PWE3.

10 mins
Multi-hop Pseudowire Setup and Maintenance using LDP
David McDysan & Florin Balus
<draft-balus-MH-PW-control-protocol.txt>
Discuss new LDP extensions, end to end signaling
procedures to address the related requirements specified
in the MH-PWE3 Requirements draft. The procedures described
in the draft enable the usage of addressing schemes (L2FECs)
and other TLVs already defined for PWs in PW Control

5 mins
The following item is subject to availability of time
Multihop Pseudowire Signaling
Himanshu Shah
DRAFT TBS
How LDP is used to signal primary and backup
bidirectional MH-PW without having to configure
switching PEs.