How-To install VMware-Tools on a SME 7.0 Virtual Machine
Author : william_syd
Tested on SME Version:
Updated :
License :
This How-to describes the way to install VMware-tools on a SME 7.0 Virtual Machine.
A cdrom must be installed in the guest os.
Do not do the first part from a remote terminal (ie PuTTy) as you will lose your network connection.
- Log in as root into the VMware console
- Select VM > Install VMWare Tools
- Click on the guest SME and log in as root
- mount /media/cdrom
- cp /media/cdrom/VMwareTools*.rpm /tmp
- cd /tmp
- umount /media/cdrom
- rpm -Uvh VMwareTools*.rpm
Do this for kernel version 2.6.9-34
- Only install the rpm at this stage.
- nano /etc/modprobe.conf
- Go to the bottom and look for 'alias eth0 pcnet32'
- Comment that line with a #
- Ctrl-x, yes, enter
- /sbin/e-smith/signal-event reboot
After it boots up, login and uncomment the line you just commented and save and exit nano.
Do this for all kernel versions
- /usr/bin/vmware-config-tools.pl
- /etc/init.d/network stop
- rmmod pcnet32
- rmmod vmxnet
- depmod -a
- modprobe vmxnet
- /etc/init.d/network start
The following can be done in a remote terminal eg. PuTTy
- ln -s /etc/rc.d/init.d/e-smith-service /etc/rc7.d/S09vmware-tools
- /sbin/e-smith/db configuration set vmware-tools service status enabled
- /sbin/e-smith/signal-event console-save
- /sbin/e-smith/signal-event post-upgrade
- /sbin/e-smith/signal-event reboot
References:
http://www.ntbrad.com/wordpress/?p=158
Back AllPages SME7Howtos
Please Note: Comments should NOT contain request for help. Please ask for help in the forum/s listed in the references section.
One page links to How-To install VMware-Tools on a SME 7.0 Virtual Machine: